Additional information
| Weight | 1.6 lbs |
|---|---|
| Dimensions | 11 × 11 × 2 in |
Crankshaft Oil Seal Kit Cummins Engine M11 – Engine ISM – Engine QSM
Rear Crankshaft Seal Kit Cummins Engine M11 – Engine ISM – Engine QSM
Rear end of the crankshaft, flywheel side. Rear oil seal with wear ring, dry-clutch application, Non-REPTO. Prevents oil leakage between the crankshaft and the flywheel housing.
Final compatibility must be verified using the engine serial number, because the same M11/ISM model may use a different oil seal depending on the flywheel, clutch, and REPTO configuration.
$80.67
In StockRelated products
-
CumminsOil Seal Kit Rear Cummins Engine M11
Rear Crankshaft Seal Kit Cummins Engine M11
Rear end of the crankshaft, flywheel side; Rear oil seal with wear ring, prevents oil leakage between the crankshaft and the flywheel housing, For certain L10, M11, ISM11, and QSM11 engines, depending on the engine configuration. Dry-clutch application, Non-REPTO.
Final compatibility must be verified using the engine serial number, because the same M11/ISM model may use a different oil seal depending on the flywheel, clutch, and REPTO configuration.
(0 reviews)$68.99 Add to cart -
CumminsExhaust Manifold Gasket Cummins Engine M11
Exhaust Manifold Gasket Cummins Engine M11
It is located between the cylinder head and the exhaust manifold; it prevents exhaust gases from escaping.
Cummins specifies the primary use for 10-liter L10 engines; aftermarket catalogs extend the application to the M11, ISM, and QSM families. Final compatibility should be verified using the engine’s serial number.
(0 reviews)$3.52 Add to cart -
CumminsBalance Shaft Bearing Set Cummins Engine ISM – Engine QSM
Balance Shaft Bearing Set Cummins Engine ISM11 – Engine QSM11 PARTS OLD #3820566
The aftermarket catalogs indicate that the engine normally requires 7 units. The kit 151565 contains a complete set of your items.
Important: The socket must be installed with pressure hardware, respecting the orientation of the lubrication orifices. After installation it may be necessary to check the internal diameter, alignment and shape of the lever shaft. You don’t have to install it directly.
They appear to be applied on some Komatsu and Doosan-Daewoo teams that use these engines. The definitive compatibility must be confirmed via the ESN.
(0 reviews)$13.94 Add to cart -
CumminsSeal – Valve Stem Cummins Engine M11 – Engine ISM – Engine QSM
Valve Stem Seal Cummins Engine M11 – Engine ISM – Engine QSM
It is used on the valve guide to prevent excessive oil from entering the combustion chamber.
Compatible engines: Cummins L10, LT10, LTA10, M11, ISM, and QSM11.
It is advisable to verify the CPL and serial number of the engine, as some configurations may use a different seal.
(0 reviews)