Cylinder Head Gasket Set Cummins Engine ISL 8.9 / ISLe 8.9 – Engine QSL 8.9
This is a set of gaskets and O-rings for the upper part of the engine, used during work on the cylinder head. It is designed to restore the seals after the cylinder head has been removed, preventing leaks. It contains various types of gaskets, O-rings, and sealing washers.
I always recommend verifying the Engine Serial Number (ESN) and CPL, as well as the ISC/ISL/QSL version. In particular, the included head gasket may have a specific thickness or configuration.
Seal the component joint to prevent oil or engine fluids from leaking. Cummins primarily uses it for 11-liter M11 engines, but it is also installed in L10, ISM, and QSM engines.
To confirm the exact application, you should check the motor’s ESN/CPL, as it may vary depending on the configuration.
The kit is installed at the front end of the crankshaft, where the shaft passes through the oil pan/front cover. The oil seal keeps the lubricating oil inside the engine while the crankshaft rotates at high speed.
Used primarily in the Cummins L10, M11, ISM, and QSM11 engine families.
Final compatibility must be verified using the ESN (Engine Serial Number) or CPL, because Cummins may use different configurations of the same engine.
The cylinder liner forms the cylindrical surface along which the piston and piston rings slide. It maintains the correct geometry of the cylinder, transfers heat to the engine block, and allows the engine to be rebuilt without having to replace the entire engine block. It is specified as a flanged cylinder liner and is supplied without sealing rings.
Cummins 6C-Series engines are also used in power plants, including the ISC 8.3, QSC 8.3, ISL 8.9 / 9, and QSL 8.9 / 9 models.
ESN – Engine Serial Number, CPL, Cummins QuickServe/OEM catalog, complete engine model and CM, stamped/cast number on the old liner, dimensional comparison of inner diameter/flange/length, or confirmation from Cummins.