Additional information
| Weight | 0.030 lbs |
|---|---|
| Dimensions | 6 × 6 × 1 in |
Fuel Pump Gasket Cummins Engine M11
Fuel Pump Gasket Cummins Engine L10 -Cummins Engine ISM-Cummins Engine QSM
$4.87
In StockRelated products
-
CumminsBalance Shaft Bearing Set Cummins Engine M11
Balance Shaft Bearing Set Cummins Engine M11 PARTS OLD #3820566
The aftermarket catalogs indicate that the engine normally requires 7 units. The kit 151565 contains a complete set of your items.
Important: The socket must be installed with pressure hardware, respecting the orientation of the lubrication orifices. After installation it may be necessary to check the internal diameter, alignment and shape of the lever shaft. You don’t have to install it directly.
(0 reviews)$13.94 Add to cart -
CumminsCover Plate Gasket Rear Cummins Engine L10
Cover Plate Gasket Rear Cummins Engine ISM – Engine QSM
Seal the engine plate or cover to prevent oil leaks.
Application for Cummins Engines: L10, M11, ISM and QSM.
Since this is a flat, lightweight gasket, you should verify its shape and holes by comparing it to the removed part or by checking the serial number/CPL.
(0 reviews)$1.55 Add to cart -
CumminsRing – Seal Cummins Engine ISM – Engine M11 – Engine QSM
Rectangular Ring Seal Cummins Engine ISM – Engine M11 – Engine QSM
It creates a static seal between engine components, preventing leaks of oil, coolant, or pressure at the specific mounting point. The exact location varies depending on the engine configuration.
Cummins specifies that this product is primarily intended for use with non-certified 11-liter M11 engines; aftermarket catalogs also list the L10, ISM, and QSM models. Final compatibility must be verified using the engine’s serial number, as it may vary depending on the CPL and configuration.
(0 reviews)$1.69 Add to cart -
CumminsMain Bearing Set STD Cummins Engine M11 – Engine ISM – Engine QSM
Main Bearing Set STD Cummins Engine M11 – Engine ISM – Engine QSM
The game is installed on the crankshaft’s main bearings, it is mainly used in non-certified 11-liter M11 engines. This corresponds to the STD size. Do not use if the crankshaft has been ground to 0.010, 0.020, 0.030, or 0.040 inches.
Exact compatibility must be confirmed with the ESN/CPL, as it may vary depending on the crankshaft configuration.
(0 reviews)$126.88 Add to cart